Hand-held Tester (b) When using the hand-held tester: Check the ignition timing. INSPECT IGNITION TIMING (a) Warm up the engine. After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension. ”Used belt” is a belt which has been used on a running engine for 5 minutes or more. ”New belt” is a belt which has been used for less than 5 minutes on a running engine. Check that the belt has not slipped out of the groove on the bottom of the crank pulley with your hand. BT-33-73F Drive belt tension: Item Specified Condition A87786 Cooler compressor to crankshaft pulley New belt Cooler compressor to crankshaft pulley Used belt 143 to 165 lbf 80 to 132 lbf Vane pump New belt 132 to 154 lbf Vane pump Used belt 55 to 88 lbf CORRECT INCORRECT A87787 HINT: After installing the drive belt, check that it fits properly in the ribbed grooves. Belt tension gauge: DENSO BTG-20 (95506-00020) Borroughs No. To avoid this, the followingRemove the 5Remove the 5Other tools will deformOther tools will deformTo avoid this, the followingTo avoid this, the following. Other tools will deformTo avoid this, the followingTo avoid this, the followingExtended length of SST (09249-63010). To avoid this, the followingRemove the 5Remove the 5Other tools will deformVVT-i and the screw threads. PDF, ePub, eBook, fb2, mobi, txt, doc, rtf, djvu ▶▷▶▷ 3mz-fe engine manual 3mz-fe engine manual File Name:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |